Basically the turret should be further forward on the Hull
1st Aspect of the issue
The Area where the gun barrel get thin should extend further out than the hull front, however its still above the hull chassis due to the turret being in the wrong position.
The turret doesnt allign with the roadwheels either.
2nd Aspect of the Issue
The gap between the turret and the driver hatches shouldn’t be this big
3rd Aspect of the issue
The turret cheek edge should line up with the 4th wheel, it lines up with the 5th instead.
4th aspect of the issue
Since the turret is too far back on the hull, the turret actually overlaps on top and over the engine venting grill
This isnt the case from actual diagrams of the tank. the engine vent grill is fully exposed and doesnt have the turret overlapping it.
